Titanium conduct bar
Titanium conduct bar mainly made as cathode in sea water or soil, the common size is 6.35*0.635mm, titanium mesh ribbon size is 12.7*0.9mm, we can provide sample for your first test.
Product Introduction
Material: Grade 1 titanium ribbon
Size: 12.7* 0.9*L
Usage: for cathdic protection
MMO Ribbon Scope of application
In seawater, the main anode product was Cl2.In soil, fresh water, brackish water and seawater, the anode products were mainly O2 or Cl2 or both.
Detailed introduction
Precious metal oxide anode is in titanium substrate (titanium ASTMB 265 level) was covered a layer of electric catalytic activity of metal oxide (ruthenium iridium titanium metal oxide), constitute, the oxide coating polarization small and consumption rate is extremely low, by adjusting the composition of the oxide layer, can make it suitable for different environments, such as sea water, fresh water, the soil medium, because of the precious metal oxide anode has the advantages of other anode don't have it has become the most ideal and most promising auxiliary anode material.
The banded noble metal oxide anode has been widely used as the auxiliary anode of the mesh cathodic protection system at home and abroad. The > cathodic protection of the newly built tank bottom plate has been widely applied. The wear rate of the MMO titanium anode coating produced by our company in various environments of the cathodic protection is very low, which is about 2mg/ a.a. and its service life can reach more than 30 years.High chemical stability, even in low PH and chloride ion containing environment also has good chemical stability;Size stability;Low and uniform coating wear rate: 1-6 mg/ a.a;Can work under high current density;Excellent electrical conductivity and other characteristics.
Product parameters
Length: 76.2 m/coil or 152.4 m/coil
Specifications
MMO titanium ribbon size - 6.35 * 0.635mm, picture is follows:The titanium ribbon anode and the backpacking are interdependent, because the direct use of the ribbon anode will corrode the anode itself and reduce the service life, while the backpacking can promote the anode to improve the output efficiency of current and increase the service life of the anode.In order to reduce the grounding resistance of the sacrificial anode, a strip of magnesium anode or zinc anode is sometimes used to lay the strip of anode along the structure of the protected device, so that the current inside the metal is more evenly distributed.When the ribbon anode is laid along the pipeline, it should be connected to the pipeline every other distance, and the distance should not be too large, because the anode will be consumed continuously with the delay of time, and the resistance of the anode belt will gradually increase, and the spacing of the ribbon anode should not be more than 305 meters.If the strip anode is buried directly in the soil 0. The anode itself may corrode, reducing its service life.Use of return packing: gypsum powder in return packing can absorb a lot of water, and sodium sulfate can make the surface of anode corrode evenly, thus improving the utilization rate of anode.
Hot Tags:
You Might Also Like
Send Inquiry
